View RSS Feed

Mikes Z car

Stripped radio fascia captive nut- make your own replacement

Rate this Entry
This is the original fascia nut and odd looking squarish washer that came out with it:

Click image for larger version. 

Name:	RIM00019 fascia nut stripped and spacer.JPG 
Views:	199 
Size:	160.0 KB 
ID:	73571

One of the captive nuts on the fascia on my car was stripped out so to fix that I made my own captive nut by cutting a rectangle shape out of a repair metal from Thrifty hardware and drilling and tapping it for the 4MM original machine screw. I used a bench grinder to make the new nut have the same size as the original and to have the beveled edges the original has.
The existing machine screw size is 4 MM and according to my drill and tap sheet the drill size to use for tapping is 1/8" (or 3.3MM) which worked well. The fascia nuts I had were stripped out bad enough that I could not be sure what the pitch was so I won't list that to avoid posting inaccurate info.
The existing captive nut can be easily removed by prying open the two metal retainer strips that are in front of and in back of the nut that hold it captive. I had to use care to pry the strips just far enough so that the stripped nut was removable as otherwise the new nut would want to fall out if the strips were sprung out.

Updated 08-30-2014 at 03:20 PM by Mikes Z car

Categories
Uncategorized

Comments