Search:

Type: Posts; User: rsperegrin1

Search: Search took 0.01 seconds.

  1. Replies
    1
    Views
    492

    '75 280Z Seats (Trash or Sell)?

    I'm putting aftermarket seats in. The stock fabric and foam is thrashed. Mechanically and functionally sound. Should I try to sell them, if so how much? Or should I dump them?
    Thanks
  2. Anyone ever bought anything ZForceProductions?

    I keep emailing them and they won't respond.

    Are they a legit business?

    Thanks!
  3. I do agree with the siamesed blocks being...

    I do agree with the siamesed blocks being stronger, but the cooling capability of a non-siamesed block should be superior? Do you agree? And for any HP under 400, not saying I can get even above...
  4. Trash this motor and start with another? 1975 280z

    Take a look at the attached picture. Piston number 5 & 6 deteriorated down to the compression ring. There should be debris through out the entire motor. It is an N42 block with an N47 heads. My plans...
  5. That is where the manual came from. If you look...

    That is where the manual came from. If you look at the site you'll see AC is missing from the 1975. There is no other choice but to look at the 74's or 76's at least on that site.
  6. Vacuumcock Identification Verification Request (1975 280z)

    Please see the attached picture. Is the item I circled in red the vacuumcock? I'm trying to find were the hose coming out of the top is supposed to connect too (identified with the red arrow)

    I'm...
  7. Air Temp Sensor Continuity Failure Mystery (1975 280z)

    Problem:
    I checked continuity between terminals 6 and 27 at the ECU - it failed

    Diagnosing Attempts:
    1) I checked the continuity between terminal 6 and 27 on the Air Flow meter - it passes...
  8. Replies
    1
    Views
    405

    Blocks & Turbo Intakes 1975 280z

    Hello,

    I have a L28 in a 75 280z. I want to add a turbo.

    1) Are there turbo fitted intakes readily available that I could install on this motor? Does does it make more sense to buy a ZX...
  9. Brake Light SW being fed from Harzard Harness (1975 280z)

    I found a speaker wire tapped into a blue wire of the Hazard SW Harness. It feds to one led on the Brake SW. While one of the Y on Blk Break SW wires dangled and the other was connected to the...
  10. 2 Cut Wires - Dangling Under Dash (1975 280Z)

    Hello,
    I'm struggling at tracing one white on green wire and one melted black wire, in the FSM & posted wire diagrams, that have been broken. They are dangling under the dash. I attached a...
  11. Replies
    14
    Views
    998

    Oh man I just trashed them.

    Oh man I just trashed them.
  12. Replies
    14
    Views
    998

    Bumpers - Market for or Not? '75 280z

    Hello,

    I pulled the 5 mile-an-hour bumpers from my 1975 280z and mounting hardware. I don't want them. I'm not familiar with the market. Are these worth trying to sell or just trash them?
    ...
  13. Replies
    16
    Views
    859

    Thanks for the ideas guys. Yes the bumpers are...

    Thanks for the ideas guys. Yes the bumpers are gone etc. And to Steve's point, nope not running yet. My brain is running down different avenues as I work on the electrical. Its a mess. I plan on...
  14. Thank you very much guys! I've been drilling the...

    Thank you very much guys! I've been drilling the FSM and just couldn't find references to the one I labeled with white and yellow. So I appreciate your help.
  15. Thank you very much guys! Really appreciated :)

    Thank you very much guys! Really appreciated :)
  16. Throttle Valve SW - No Continuity ('75 280Z)

    Hello,

    Noticed the harness to the TV SW disconnected when I bought the car, not running, 2 weeks ago.

    Started following the SM section EF "Engine will not start." I received no continuity...
  17. 4 Sensors (Thermo, Water, X? and Y?) '75 280Z

    62479
    Sorry about the pic rotating 90 degrees CC


    Hello,

    I attached a picture of 4 sensors just below the thermostat housing of a 75 280z.

    1) please correct me if I'm wrong but the one I...
  18. Replies
    16
    Views
    859

    My bad, I should have been more specific. Road...

    My bad, I should have been more specific. Road only, light to light, I would like to focus weight reduction on body, if possible. Seats yes, heater, AC, PB, PS etc I would like to keep
  19. Replies
    16
    Views
    859

    Reducing Vehicle Weight

    Hello,

    I want to trim weight from my '75 280z. I would love to drop 350lbs. Any one have any experience and can give me some advice?

    Thanks
    Robert
  20. Hey Guys, I pulled a Newbee mistake. I had...

    Hey Guys,

    I pulled a Newbee mistake. I had the car in neutral. Thats why the starter wasn't turning. But it gave me my first thrill and dig.

    1) I am getting spark at the plugs but no...
  21. Thanks for the diagram, it is impressive. What...

    Thanks for the diagram, it is impressive. What do you mean by putting extra twist in to the rod?
  22. Cranks, Cams & Pistons - Who's Mfg these for Z-Cars?

    Hello,

    Can anyone give me a list of aftermarket custom crank, cams, piston and head manufactures for L28 motors?

    Thanks
    Robert
  23. 75' 280z Starter not starting - any ideas would be appreciated!

    Hello, I just bought a 1975 280Z.

    The starter works when I jump it, but not when I turn the key (ignition). I verified the is no power coming from the wire (connected to the starter) that is...
Results 1 to 23 of 23