Search:

Type: Posts; User: Pomorza

Page 1 of 4 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    9
    Views
    754

    Rear hatch seals

    Hey mates

    So both my rear hatch seals - the two rubber things that go around the rear hatch - are leaking. I've replaced both in the past but at the top it seems that both have come off and ripped...
  2. Thread: Steering issue

    by Pomorza
    Replies
    10
    Views
    955

    Chuck I grabbed the tire from the top and it...

    Chuck

    I grabbed the tire from the top and it doesn't really budge. When I grab it at 9 and 3 it moved a bit and makes a clunking noise from the engie bay area (or basically straight ahead of the...
  3. Thread: Steering issue

    by Pomorza
    Replies
    10
    Views
    955

    Update. So this morning my car has a new...

    Update.
    So this morning my car has a new annoying and rather terrifying symptom. At highway speeds - above 60 - the steering wheel will vibrate left and right but only sometimes. One moment the...
  4. Thread: Steering issue

    by Pomorza
    Replies
    10
    Views
    955

    Steering issue

    Hey mates

    While driving back home from work today I was forced to brake hard on the freeway (basically went from 75 to 30 in a rather short distance). When I reapplied the gas my car jerked, as if...
  5. Replies
    39
    Views
    1,226

    Hey mate I do have one question. For my...

    Hey mate

    I do have one question. For my understanding the tensioner is not supposed to have ANY slack during the first install. Looking at your picture with the chain I can see there's a bit of...
  6. Replies
    2
    Views
    411

    Checking rear wheel bearings

    Hello all

    I drove a tad over 250 miles today for the holiday and I'm hearing an odd noise from the rear. What is the best way to check the rear bearings on these lovely cars? Should it leave the...
  7. Replies
    4
    Views
    245

    You may have hit the nail on the head there. I...

    You may have hit the nail on the head there. I went for a short (roughly 5 mile drive) this morning. Got the engine nice and warm and went through all the gears (minus 5th). When I got back I put the...
  8. Replies
    4
    Views
    245

    Transmission Temp

    Hey mates

    This evening I was driving my buddy home from my place. Total drive time was about an hour mostly speed at or above 45 mph - so in 4th gear or higher. When I got home I noticed that my...
  9. Replies
    4
    Views
    335

    Is there enough room there just to pull the studs...

    Is there enough room there just to pull the studs out with all the brake hardware removed?
  10. Replies
    4
    Views
    335

    Black Gold Man Seriously, can I do this to all...

    Black Gold Man

    Seriously, can I do this to all the studs? Can I remove the dust shield also?

    Thanks
    Jan
  11. Replies
    4
    Views
    335

    Lug stud issues

    Hey mates

    A few weekends ago I went over to the local tire shop to have my brakes bled - basically redid my front discs and needed the air out. Well they pulled all four tires off and bled the...
  12. Replies
    1
    Views
    273

    Temperature guage connector

    Hey mates

    I've asked this question before but for the life of me can't seem to find it again. The connector that connects the temperature guage to the sensor in the thermostat housing. Does anyone...
  13. Thread: Spindal bolts

    by Pomorza
    Replies
    2
    Views
    313

    Spindal bolts

    Ladies and Gents

    Have a question for you guys. My Z is making a rather annoying squeaking noise from the front suspension occasionally. I took the tire off and tightened everything on the front...
  14. Thread: Strut movement

    by Pomorza
    Replies
    8
    Views
    396

    Thank you all for the help. Got under the car...

    Thank you all for the help. Got under the car today and found that the two 18mm bolts that hold the strut to the lower control arm were, loose is a nice word. I tightened these and everything else -...
  15. Replies
    2
    Views
    280

    Zed Head That said wire is sadly gone, fell...

    Zed Head

    That said wire is sadly gone, fell off when I was doing the front cover a while ago. Should I just add a ground to the distributor?

    Thanks
  16. Replies
    2
    Views
    280

    A quick question

    Hey mates

    A few years back I did the ZX dizzy conversion on my Z. This past weekend, when checking everything I noticed that the little tab on the front of the distributor - near the vac advance -...
  17. Thread: Strut movement

    by Pomorza
    Replies
    8
    Views
    396

    Mates New sympton to mension. When I go over...

    Mates

    New sympton to mension. When I go over bumps there's a squeaking noise (loudish) coming from the right front area.

    Thanks for the advice
    Jan
  18. Thread: Strut movement

    by Pomorza
    Replies
    8
    Views
    396

    When you say locking nut do you mean the one on...

    When you say locking nut do you mean the one on top of the shock? I'll take a look at all of these on my next day off.
  19. Thread: Strut movement

    by Pomorza
    Replies
    8
    Views
    396

    Strut movement

    Hey mates

    This past weekend I did an oil change on my Z - added some zinc which made it worth while. While I had the car in the air I grabbed the passengers side wheel to make sure the bearing and...
  20. Replies
    7
    Views
    450

    Zed Head I used to live in Florida so I'm not...

    Zed Head

    I used to live in Florida so I'm not expecting anything new, minus more rain as we get something like 8" all year here. Thanks mates for the replies, will let you all know how things go. ...
  21. Replies
    7
    Views
    450

    Georgia on my mind

    Hello mates

    It looks as if in the near future I will be moving down to Georgia - Savannah to be exact - for a job. A couple questions, any thing I need to know about registering my Z down there?...
  22. Thread: Flywheel

    by Pomorza
    Replies
    5
    Views
    586

    Flywheel

    Hey guys

    Quick question. Is the flywheel from an L20B the same as the one on in the L28E?

    Thanks
    Jan
  23. Thread: vibration

    by Pomorza
    Replies
    11
    Views
    934

    On the topic of clutches, which ones do you guys...

    On the topic of clutches, which ones do you guys run? Do you like/dislike them?

    Thanks
    Jan
  24. Thread: vibration

    by Pomorza
    Replies
    11
    Views
    934

    Yup sounds just about right. Doesn't really do it...

    Yup sounds just about right. Doesn't really do it when its cold - or I haven't noticed - does do it when its hot. Well when I gather the money together I'll probably spend it on a new clutch.
    ...
  25. Thread: vibration

    by Pomorza
    Replies
    11
    Views
    934

    Zed It happens as I'm engaging the clutch and...

    Zed
    It happens as I'm engaging the clutch and taking off from a dead stop.
Results 1 to 25 of 100
Page 1 of 4 1 2 3 4