Search:

Type: Posts; User: 71Ugarte

Search: Search took 0.01 seconds; generated 7 minute(s) ago.

  1. There's a lot of good information there. I'll...

    There's a lot of good information there. I'll read through it a few times.
    Thanks
  2. I'm trying to decide if I want to section my...

    I'm trying to decide if I want to section my strut housings or not,but probably will. From what I understand you can do it anyway you want as long as your inside length allows for the strut and...
  3. Did you see this one? HOW TO: The most...

    Did you see this one?

    HOW TO:

    The most current version of my how-to is always here:

    http://www.betamotor...Sectioning.html

    The text is copied and pasted below:
  4. Replies
    0
    Views
    450

    GC Coilovers with Tokico Blues

    I've been going back and forth about getting GC coil overs. I have heard that the Tokico Blues will and will not work with the coil overs. Does anyone know for sure? I also understand that sectioning...
  5. Replies
    13
    Views
    2,284

    Perfect. I will gather all the parts so that I'm...

    Perfect. I will gather all the parts so that I'm ready to rebuild mine.
    Thank You
  6. Replies
    14
    Views
    821

    Figured out the tach redlining problem. It was a...

    Figured out the tach redlining problem. It was a loose resistor in the tach circuit board. All good now.
  7. Replies
    13
    Views
    2,284

    I figured mine out today it was a loose resistor...

    I figured mine out today it was a loose resistor inside the tach. This would make sense that some people say that temp. effects the tach. As it expands and contracts with temp change, the connections...
  8. Replies
    13
    Views
    2,284

    beermanpete, do you know what components go bad...

    beermanpete, do you know what components go bad in the tach? I cant find a schematic for the internals.
  9. Replies
    14
    Views
    821

    Worked great except for my 280z tach. I did...

    Worked great except for my 280z tach. I did everything as I was supposed to ,but maybe the tach is shot. It pegs out. I did try the 10K Ohm resistor too. I'll do a search for the autometer tach....
  10. Replies
    14
    Views
    821

    Good info. I'll get a Crane PS20 or the MSD...

    Good info. I'll get a Crane PS20 or the MSD Blaster. Thanks
  11. Replies
    14
    Views
    821

    ZX Dist in 240Z

    OK, I have everything I need for my ZX Dist swap. The only thing I am not sure of, is what coil I need. I have the ZX tach in place and a wire running to the coil +. What after market coil will work...
Results 1 to 11 of 11