Search:

Do a fuel pump cut off and put it somewhere inconspicuous.

Real black pearl? Nice either way.

DeoxIT is good stuff.

As a side note, if you plan on doing any track racing, most sanctioning bodies require a well-marked, rear mounted cut off switch be installed. Run a line from the alternator feed to the switch to...

Short answer: yes, all 6-cyl mechanical rocker camshafts are interchangeable. Slight difference in lift/duration/profile across years, I believe. I recommend to ALWAYS keep rockers and camshafts...

Don't forget ape hangers :)

If you read my other thread, you'd know that I can't get spark.

What's happened since we pulled and put the engine back in:
Car will only spark AFTER cranking.
Getting +12V @ BOTH sides of the...

Triple checked the plug wires. I tried wiring the E12-80 both ways; no dice. Tried the points dizzy I had, no spark.

Did a couple tests with a multimeter, though. found that both sides of the...

That looks to be a well-executed conversion. To my untrained eye it looks like the Alpha one kit

We had the car running before we pulled the engine to replace a gasket and the cam. Today, after reinstalling, the car won't start. After cranking, it seems like it wants to start for a couple...

Ah yes, Jackie Chan and his partnership with Mitsu :)

I have that as one of the 6 that I bookmarked while searching earlier :) The FSM is identical to the hard copy I have, but there were still some wires that I still wasn't sure about; although now I...

Well I'm currently elbows deep in a project with some ***** wiring and I was wondering if someone could help. I basically had to strip down the harness from where I connect to the ignition coil and...

Welcome! I'm in Santee; I'm going to be working with AoK on the San Diego Grassroots Challenge, but I'll be down to help when I can!

I doubt that this eBay ID will remain valid for long; doesn't seem like a long time eBayer.

But still, I certainly hope that eBay is informed

Great read.







And my car's faster :P

Someone got a killer deal! Although with this economy it's not surprising that not many bidders came out of the woodwork. I wonder if it was someone from this site?

This may be a little bit of a 'tuner' magazine for most on this site, but I know I have gained much knowledge from the likes of Dave Coleman et al. Especially the "Rally Beater" 510



Source...

Way too many pix to sit and upload :) But just imagine a showroom, automatic, silver 1973 and you'll get the picture :)

http://cgi.ebay.com/ebaymotors/Datsun-Z-Series-240z-1973-72-71-70-240z-Survivor-5-786-miles-Time-capsule_W0QQcmdZViewItemQQ_trkparmsZ72Q3a543Q7c66Q3a2Q7c65Q3a12Q7c39Q3a1Q7c240Q3a1318QQ_trksidZp3286Q2e...

It's growing on me. I must say that the side shot made all the difference in the world to me. But then again, I have also learned to like the Z33. Still, I find this new design an improvement,...

Yay Vic! Welcome back!

Well, I missed a can of worms while I was away!

Welcome back, i guess?

I plan on using some of that graphite wheel paint and then spraying it with a satin clear coat. A lot cheaper and it will still look decent.

Man, I was just up in Riverside a few days ago at Castle Park lol

Well, that was the first time staring it after 12 months of not running. I had relocated the batt to the back and did the IR alternator conversion. Messed up with the diode so it didn't shut off,...