Search:

Type: Posts; User: kirkE

Search: Search took 0.00 seconds.

  1. Replies
    2
    Views
    2,137

    you dont' happen to have the larger m22x1.5x30...

    you dont' happen to have the larger m22x1.5x30 bolts that fit into the top of the control arm by chance? I need one
  2. looking for m22x1.5.30 rear control arm bolts for 1970 240z

    I have lost one of the rear control arm bolts and having a heck of a time finding a replacement. Any one have one for sale or can tell me who still supplies these bolts?
  3. Replies
    4
    Views
    1,292

    no electrical power on a 1977 280z

    I was changing out the starter and like a DA reversed the + and soleinoid connections. After realizing my mistake, and a few cranking moments later, I reversed the connections. Now I have no...
  4. Replies
    13
    Views
    1,321

    Ok - blew out all the lines, car ran great in the...

    Ok - blew out all the lines, car ran great in the 6 mile test run. I think it is fuel.

    Thanks for all the great suggestions
  5. Replies
    13
    Views
    1,321

    I did have the tank boiled out and coated. But,...

    I did have the tank boiled out and coated. But, that said when I drained the tank the drain plug was coated over with this rubber type coating. It got me thinking about the pick up tube and so I...
  6. Replies
    13
    Views
    1,321

    70 Z goes great for about 4milies then dies

    Ok - I am stumped, new points, dist, coil, cap, new fclear fuel filter with gas drained and lines blown out. Car will idle for hours, drive 4 to 5 miles after it reaches temperature and it starts to...
  7. Replies
    30
    Views
    4,272

    early 70 am/fm radio -

    From the factory wiring harness I have a blue fused wire, a white wire and a white/blue wire. Problem is that both the white and white/blue have been cut at the connector and I don't know where they...
  8. Replies
    637
    Views
    94,330

    tennessee tumbleweed

    I have an original 1970 that is titled as a 71
  9. Replies
    7
    Views
    1,574

    Guys I am having a heck of a time getting the...

    Guys
    I am having a heck of a time getting the idle correct on a 70 240z. Engine has just been professionally rebuild, Ztherapy did the carbs. Dist is original but has been cleaned up. I have to...
Results 1 to 9 of 9