Search:

Type: Posts; User: MEZZZ

Page 3 of 4 1 2 3 4

Search: Search took 0.01 seconds; generated 62016 minute(s) ago.

  1. Replies
    15
    Views
    4,721

    The "paintable" one is what I used first. It went...

    The "paintable" one is what I used first. It went on fairly smooth but had a little texture. It dried pretty flat. I used that under the entire rear of the car after removing the suspension and gas...
  2. Replies
    6
    Views
    734

    I thought I would jump in. I bought this set off...

    I thought I would jump in. I bought this set off of Ebay a couple years ago for $144.00 shipped. I was very happy with them. They are stock units, cleaned, tested and then matched up in a set from...
  3. Replies
    56
    Views
    6,284

    I finally got mine installed yesterday Dave, cant...

    I finally got mine installed yesterday Dave, cant wait to get it out on the road. The mount went in without a hitch, fit perfectly! I had to pull the diff out after the initial try as I had put the...
  4. According to Ac Delco's website, the cable fits...

    According to Ac Delco's website, the cable fits 75-78 models. It came with everything needed. The springs went on using the "keyring" method, just a little taxing but they went on. The stock hangers...
  5. Thanks guys. I figured that to be the only way,...

    Thanks guys. I figured that to be the only way, the "keyring" method" My nephew was here last night and tried that and it was digging into the plastic sheathing of the cable so he stopped. I didnt...
  6. Replies
    15
    Views
    4,721

    I have my whole rear suspension out. WHile back...

    I have my whole rear suspension out. WHile back there, I cleaned as much of the old crud, (dirt, grease, old undercoating) off that I could. I did this from the driveshaft tunnel to the rear panel.
    ...
  7. aftermarket ac delco parking brake cable question

    I bought an aftermarket parking brake cable from Rockauto,com
    I couldnt justify the $300 + for a stock one from MSA, the aftermarket was around $65.

    My question lies with the springs that came...
  8. Thread: Rear Hatch Rust

    by MEZZZ
    Replies
    3
    Views
    374

    Seeing where you are from, I doubt you will find...

    Seeing where you are from, I doubt you will find any early Z's in a junkyard. Best bet is craigslist. I found a couple hatchs on there. Still not perfect but much better than what the original was....
  9. Replies
    19
    Views
    4,080

    I had a 1/2 cover on mine when I got it and it...

    I had a 1/2 cover on mine when I got it and it was very obvious. I went to replace the tach and the only way to get it out the front was to remove the cover, gave me a reason to buy a full cover from...
  10. I just went back and referenced the Atlantic Z...

    I just went back and referenced the Atlantic Z tech tip. The photo clearly showed the hose going in the top plug, not the breather tube as I had thought earlier. It states to fill unitl it comes out...
  11. thank you guys! I will drain and refill with 1.3...

    thank you guys! I will drain and refill with 1.3 liters per your suggestion Carl. Not sure if it is a R180 or R200, it is a '77. From the amount of filth that came off of it and the entire underside,...
  12. Differential fluid question, conflicting information

    I am confused and need some direction. I am in the process of tearing out and rebuilding the rear end. I have a question on the level of gear oil to put in the differential. I have read on here (yes,...
  13. Replies
    7
    Views
    1,986

    yes, I did read about that. I didnt do it with...

    yes, I did read about that. I didnt do it with the front end rebuilt but have put less than 10 miles on it since then.
    I asked my wife (and received) a set of ramps for a christmas gift just for...
  14. Replies
    7
    Views
    1,986

    Mike, I finally got around to working on my...

    Mike,
    I finally got around to working on my differential removal today. I took your advice and it worked like a champ! Thanks so much for the tip.
    Unfortunately, I had to grind down a 12mm to...
  15. Replies
    3
    Views
    1,154

    I bought edead as well after reading a series of...

    I bought edead as well after reading a series of test on several sound deadeners. It came in 2nd and was much cheaper than Dynamat. I picked up to rolls, 60 sq/ ft for $70.00 shipped on Ebay.
  16. I swapped mine out last fall. The front was...

    I swapped mine out last fall. The front was fairly easy, I used a fiberglass one that I bought from MSA, couldnt find a decent original without paying through the nose.
    The rear is a bit harder. I...
  17. Thanks for the tip on Ralph guys, I will check...

    Thanks for the tip on Ralph guys, I will check him out.

    moonpup, I tried a search on Courtesy last night before posting this request. I dont have the part numbers though. I pulled out my F.S.M....
  18. Help sourcing a couple rear brake parts please

    I am trying to find a couple rear brake items. I am in the middle of redoing the rear end of my car, struts, diff mount, bushings, spindle pins, etc. I am also tearing down and rebuilding the rear...
  19. Replies
    16
    Views
    1,611

    I will agree to that. Of the 12 or so Ive seen,...

    I will agree to that. Of the 12 or so Ive seen, 3-4 might have qualified for the category though :)
  20. Replies
    16
    Views
    1,611

    Same here, try finding one in Ohio! After I had...

    Same here, try finding one in Ohio! After I had mine shipped from the Great Northwest, they started popping up all over the place. In the past 2 years, I have seen 12 S30's in my city! They are...
  21. Replies
    29
    Views
    2,987

    Not to jack this thread but to throw out this...

    Not to jack this thread but to throw out this option that I have read up on in some forums. Not sure that it is show quality but have read good things, especially for the price....
  22. Thread: Repair estimate

    by MEZZZ
    Replies
    11
    Views
    1,266

    What color did you go with? I really like it and...

    What color did you go with? I really like it and it is similar to what I have been looking for when(ever) I get around to painting(hopefully this summer) my car.
  23. Replies
    21
    Views
    1,494

    As a 10 year old, I remember seeing a new '70...

    As a 10 year old, I remember seeing a new '70 model and thinking it was "cool". In high school, a "hot" teacher from my freshman year drove a '73 and I though it was cool. In '77, my senior year, my...
  24. Replies
    7
    Views
    1,986

    Thanks for the info, I will give that a try. I am...

    Thanks for the info, I will give that a try. I am thinking the nuts are 12mm that I am attempting to bust free on the driveshaft. I will grind one down and see if I can get your tip to work for me....
  25. Replies
    7
    Views
    1,986

    The dreaded spindle pin removal and more!

    I pulled out some of the rear suspension last week. My plan is to replace struts, springs, brakes, brake lines, bushings, install the R/T mount, etc.

    After some hassle, I got the half shaft bolts...
Results 51 to 75 of 94
Page 3 of 4 1 2 3 4