Search:

Type: Posts; User: zbane

Page 4 of 4 1 2 3 4

Search: Search took 0.02 seconds; generated 57373 minute(s) ago.

  1. Thread: my 280zx

    by zbane
    Replies
    4
    Views
    1,442

    a quick search online found a place called...

    a quick search online found a place called windshieldstogo with replacements at $125. Before going the online route, I'd call around to the shops from Waynesville to Asheville... as well as checking...
  2. Thread: turbos

    by zbane
    Replies
    10
    Views
    1,014

    sure, you could go that route...if you have about...

    sure, you could go that route...if you have about 5,000 bucks to spare... or you could source an L28et motor from a turbo ZX...
  3. Thread: my 280zx

    by zbane
    Replies
    4
    Views
    1,442

    Removing the trim from the upper and lower edges...

    Removing the trim from the upper and lower edges of the windshield is fairly easy; the vertical portions are less so.

    To pop the upper SS trim, grab the trim near the center of the car, and pry...
  4. Thread: turbos

    by zbane
    Replies
    10
    Views
    1,014

    The easiest thing to do would be to find a...

    The easiest thing to do would be to find a complete turbo engine, with all the control modules, and swap it in. Once it's in there, you could then start looking for turbo upgrades.
    If you were to...
  5. Thread: Muffler Help

    by zbane
    Replies
    2
    Views
    1,781

    Did the exhaust system you bought from Advance...

    Did the exhaust system you bought from Advance come in on piece? That would be one heck of a shipping box... If it did, you should be able to snake it in with the car jacked, and the rear left wheel...
  6. Replies
    4
    Views
    1,284

    The antenna unit is pretty easy to remove and...

    The antenna unit is pretty easy to remove and disassemble. Odds are you need to re-grease the drive mechanism. If I recall correctly, you only have to remove three screws on the antenna assembly,...
  7. Replies
    15
    Views
    1,134

    IMO, there is no reason to discount the 260. I...

    IMO, there is no reason to discount the 260. I think that due to it's limited production run, there's a level of uniqueness to an already unique line of car. If you search around, you'll find that...
  8. Replies
    15
    Views
    1,134

    Take a piece of felt and a good magnet when you...

    Take a piece of felt and a good magnet when you look at the cars. Check the frame rails, underside of the floopans (even if the undercoating looks good, there can still be rust). Run the magnet over...
  9. Replies
    8
    Views
    1,358

    The noise suppressor is (or should be) mounted...

    The noise suppressor is (or should be) mounted with the ignition coil, on the mounting bracket itself. It may well be disconnected, missing, or simply worn out...
  10. Thread: Removing Trim?

    by zbane
    Replies
    4
    Views
    1,944

    Hopefully you won't find what I found under the...

    Hopefully you won't find what I found under the rubber outer...
    I was able to find a rear bumper from an 82 model (same extended rubber edges as on your year) but due to the extended section,...
  11. Replies
    10
    Views
    8,704

    Do you have a copy of the Factory Service Manual?...

    Do you have a copy of the Factory Service Manual? If not, PM me your email and I'll forward you a PDF copy.
    You'll be able to find all the routing for the vacuum lines, as well as electrical...
  12. Replies
    7
    Views
    2,823

    You could always get the full cap, and cut a hole...

    You could always get the full cap, and cut a hole for the sensor...after measuring and marking it's location a few times of course.
  13. Replies
    7
    Views
    2,823

    Roman, the pics you posted are for the s30 cars,...

    Roman, the pics you posted are for the s30 cars, not the later s130 (280zx) cars, though I'm sure you know this already.
    No, you don't have to remove the dash, just clean yours really well before...
  14. Replies
    44
    Views
    9,618

    Here's a link to what appears to be a decent starting point...

    http://nashville.craigslist.org/cto/2734814526.html
    Yes, it's in the Nashville, TN area, but for the money, you might do well to consider it...

    (though I wouldn't doubt if the car has 167,000...
  15. Replies
    13
    Views
    3,818

    There *should* be a thin plastic piece with...

    There *should* be a thin plastic piece with little hooks/barbs on it running the length of the glass, in the gap between the glass and the body. Yours may be there, but those little parts that clip...
  16. Replies
    133
    Views
    19,661

    After some searching, I finally found a few of...

    After some searching, I finally found a few of the Nissan Skyline 2000gt-r

    Gotta give kudos to the folks at Mattel for choosing such a cool car, and for the detailing.
  17. Replies
    12
    Views
    3,912

    Actually, the S130 fuel tanks do not have a drain...

    Actually, the S130 fuel tanks do not have a drain plug but loosening/removing the fuel filler hose (at the tank, obviously) will do the trick, though this method doesn't completely remove all the...
  18. Replies
    9
    Views
    4,913

    Welcome to the forum. I have a couple thoughts...

    Welcome to the forum.

    I have a couple thoughts on your particular issue... it sounds to me as though you are having a fuel starvation issue; that it occurs once the engine is warmed up may be a...
Results 76 to 93 of 93
Page 4 of 4 1 2 3 4