Search:

Type: Posts; User: Curtis240Z

Page 2 of 4 1 2 3 4

Search: Search took 0.01 seconds; generated 69176 minute(s) ago.

  1. Replies
    10
    Views
    1,543

    Suspension Techniques. I like them because the...

    Suspension Techniques. I like them because the center supports are real solid unlike some other manufacturers.
  2. Replies
    10
    Views
    923

    I've rebuilt one transmission and had two more...

    I've rebuilt one transmission and had two more rebuilt for me. The bearing closest to the top gear develops slop and the shifter pops out of gear during deceleration. The howl you talk about...
  3. Replies
    10
    Views
    923

    The most common cause is the countershaft bearing...

    The most common cause is the countershaft bearing in the trans is worn out thus allowing the gears to separate during deceleration. So since you need to open the trans to replace the bearing, it...
  4. Replies
    2
    Views
    677

    The OEM lamp socket needs to be grounded. The...

    The OEM lamp socket needs to be grounded. The OEM tach case is grounded. If you look closely you will notice a small copper finger that touches the tach case when you clip in the lamp socket. I...
  5. Replies
    32
    Views
    3,143

    The hot ticket back in the day, was to remove the...

    The hot ticket back in the day, was to remove the weight attached the underside of the piston for faster throttle response.
  6. Thread: T/S flasher

    by Curtis240Z
    Replies
    7
    Views
    996

    Did you always have this problem? The flasher...

    Did you always have this problem? The flasher unit is polarity sensetive. My wiring diagram says the green wire goes through the hazard switch, which gets power from the fuse box. Low voltage is...
  7. Replies
    12
    Views
    1,036

    what about oil sheen in your radiator water?

    what about oil sheen in your radiator water?
  8. Replies
    26
    Views
    1,633

    The black rubber antenna signals to me that for...

    The black rubber antenna signals to me that for whatever reason that person chose the cheap way out. I like the OEM antenna or the aftermarket black chrome antenna. My 2 cents.
  9. Thread: T/S flasher

    by Curtis240Z
    Replies
    7
    Views
    996

    You do know that the flasher unit for the hazards...

    You do know that the flasher unit for the hazards do not share with the turn signals, right? The turn signal flasher is located under the steering column.
  10. Replies
    5
    Views
    1,367

    Thanks guys I got the owner of the oldest...

    Thanks guys I got the owner of the oldest locksmith in town to cut it for me via my key code. He understood what I wanted vs. his young helper that said my key doesn't look too bad. Then the owner...
  11. Replies
    5
    Views
    1,367

    Key blank cutter gun

    Does anyone by chance have a key blank "gun" that cuts the OEM oval key by dialing in the OEM key number stamped on the OEM key? The local dealer here no longer has theirs.
  12. Replies
    10
    Views
    1,717

    Yes the automatic to manual trans swap is very...

    Yes the automatic to manual trans swap is very doable especially with a donor car. I did the swap on my daughter's 240Z. Since you already have an automatic you won't have to cut the tunnel because...
  13. Replies
    10
    Views
    1,717

    Funny, all four '71s in my family have vertical...

    Funny, all four '71s in my family have vertical defroster lines and I know at least 3 out of the 4 have original glass.
  14. Thread: Fuel???

    by Curtis240Z
    Replies
    7
    Views
    734

    If you say the fuel pressure is good and you...

    If you say the fuel pressure is good and you replaced your pressure regulator and cleaned the lines, then it has to be insufficient fuel quantity from your fuel pump. Did you do a fuel quantity test?
  15. Replies
    10
    Views
    1,717

    You should make a list of parts you need and we...

    You should make a list of parts you need and we can tell you if it is interchangeable. If it is an early 260Z you will have a better match. The hood and rear hatch will swap although the 260Z hatch...
  16. Replies
    12
    Views
    1,648

    Yes bridges are used in the fuseboxes. The white...

    Yes bridges are used in the fuseboxes. The white with red stripe is a main power lead that is connected separately from the plastic multiconnectors.
  17. Replies
    4
    Views
    1,482

    A lot of times it is just a poor connection...

    A lot of times it is just a poor connection between the female bullet connector and the sensor. Check the operation of your gauge by grounding the sensor wire (it should peg the gauge with the...
  18. Replies
    28
    Views
    7,100

    Very well said. I don't really care for the...

    Very well said. I don't really care for the stability control, so I rigged up a timer that turns off the stability control everytime I start the 370Z. I can turn it back on if I want by pressing...
  19. Replies
    28
    Views
    7,100

    I like the 370Z, I bought the Sport Model with...

    I like the 370Z, I bought the Sport Model with the Rev-matching 6 speed. It looks a lot better than the 350Z and is styled more like the 240Z. The 370Z is the closest thing you can get to a 240Z...
  20. Replies
    2
    Views
    552

    Well you eliminated half the battle by confirming...

    Well you eliminated half the battle by confirming spark to the spark plugs. Verify you are getting gas to the carburators. Since you have dual Webers, press down the throttle linkage and look down...
  21. Replies
    7
    Views
    730

    There is a full diameter engine plate between the...

    There is a full diameter engine plate between the engine and the flywheel on a MT. The AT has a "upper half" plate only with a sheetmetal bolt-on bottom section to access the torque converter bolts.
  22. Replies
    3
    Views
    642

    While the 34mm venturis will help, it will still...

    While the 34mm venturis will help, it will still run out of breath vs. using 44PHH Mikunis. My buddy did the same thing you want to try and ultimately went to a 44PHH and the high end immediately...
  23. Replies
    24
    Views
    3,464

    A small leak will increase the idle. A large...

    A small leak will increase the idle. A large leak and the motor can't stay running thus the lower than normal idle.

    To verify, block off the manifold at the large rubber hose to the brake...
  24. Thread: detonation?

    by Curtis240Z
    Replies
    4
    Views
    880

    I set total advance at 36 degrees.

    I set total advance at 36 degrees.
  25. Replies
    45
    Views
    3,486

    If I recall Vic won on the 9/11 year when we...

    If I recall Vic won on the 9/11 year when we raced only one track, so that isn't a total picture of what could of happened because the two tracks usually favor different strengths (power vs....
Results 26 to 50 of 99
Page 2 of 4 1 2 3 4