Search:

Type: Posts; User: Ed

Page 2 of 4 1 2 3 4

Search: Search took 0.03 seconds; generated 80100 minute(s) ago.

  1. Thread: Illegal window tint

    by Ed
    Replies
    22
    Views
    2,849

    Illegal window tint

    I was pulled over a couple of days ago for having illegal window tint. I never really thought much about it since I've had it on for so long. The officer had a little measuring device and my tint...
  2. Replies
    4
    Views
    757

    Mine all measured the same 34mm.

    Mine all measured the same 34mm.
  3. Replies
    4
    Views
    757

    Are you talking about where the manifold meets...

    Are you talking about where the manifold meets the head or valve seat area?
  4. Thread: L28 piston height

    by Ed
    Replies
    2
    Views
    697

    Without going into what head, how much has it...

    Without going into what head, how much has it been shaved all together etc.. try using two head gaskets. I had a +.010".
  5. Replies
    1
    Views
    754

    Discriminating car show

    Car show go'ers beware! I entered my car at a local car show this past Saturday. Never been to this show, first time, I figured why not. I've been doing pretty good at other shows elsewhere. My first...
  6. Replies
    32
    Views
    2,986

    Wow, all "no's" so far. I like the clear vinyl...

    Wow, all "no's" so far. I like the clear vinyl idea. IIRC you cut to fit then wet the body surface with water apply the vinyl and squeege it out.
  7. Replies
    32
    Views
    2,986

    Mud guards? Yes or No?

    I don't know. What do you all think should I put them on or not? They are polished aluminum.
  8. Replies
    6
    Views
    998

    Thanks guys, I kind of figured as much. Good to...

    Thanks guys, I kind of figured as much. Good to hear that it's normal.:classic:
  9. Replies
    6
    Views
    998

    Rough idle when cold

    I pull the choke back about 1/2 way and she starts just fine. If I drive her right away she will buck a little and run pretty rough. After she warms up she runs great, idles at about 800 rpm. No...
  10. Give me a yell when your ready for the rubber...

    Give me a yell when your ready for the rubber boot that goes around the harness on the firewall by the battery tray. I have them.
  11. Replies
    14
    Views
    2,356

    Nope, you can use a single piston from a...

    Nope, you can use a single piston from a different engine. But before you use it, it must be measured, weighed, and balanced along with the other pistons. So that all 6 pistons are the same weight...
  12. Thread: Rebuild Kit

    by Ed
    Replies
    1
    Views
    1,134

    Just pulled this off another post. ...

    Just pulled this off another post.
    http://www.drivetrain.com/nissian4_5sprwd.html
  13. Replies
    1
    Views
    979

    I hope you took a minute to lube your bolts with...

    I hope you took a minute to lube your bolts with some anti-seize. This will prevent the bolts from rusting onto the block and breaking in the future. Also you should remove your alternator while your...
  14. Thread: engine smoke?

    by Ed
    Replies
    2
    Views
    829

    Sounds a little confusing, do you have any more...

    Sounds a little confusing, do you have any more symptoms? Have you started her since? Sound like a good carb tune up in in order.
  15. Replies
    31
    Views
    3,932

    Nate, Depending on the type of work you intend...

    Nate,
    Depending on the type of work you intend to do will determine the type of grinder you will need. If you intend to cut and grind away rust in those small areas your mentioning then a 3" high...
  16. Thread: Tranny Noise

    by Ed
    Replies
    7
    Views
    1,343

    You can pull the drain plug, there is a magnet...

    You can pull the drain plug, there is a magnet attached to it. If there are metal pieces attached then you know you've got bad internals.
  17. Replies
    14
    Views
    2,356

    It's only a bad idea to mix pistons when you use...

    It's only a bad idea to mix pistons when you use only one or two pistons from a different engine and not balance them. If you use all 6 pistons you will not have a problem. This is because the...
  18. Replies
    17
    Views
    2,239

    Sweet, I'll have to put this on my calendar.

    Sweet, I'll have to put this on my calendar.
  19. Thread: Headliner ?

    by Ed
    Replies
    2
    Views
    1,119

    I did the same. Almost 2 years now still holding...

    I did the same. Almost 2 years now still holding strong.
  20. Replies
    39
    Views
    3,370

    I did the same thing, once. A long, long time...

    I did the same thing, once. A long, long time ago. Almost killed the battery trying to star the car. Until I remembered the switch. :stupid:
  21. Replies
    15
    Views
    2,512

    I used the same stuff as Beandip. I applied it to...

    I used the same stuff as Beandip. I applied it to the roof and put the headliner over it. This was two years ago and she is still holding strong. I also applied it to the outer skin on my doors....
  22. Replies
    9
    Views
    997

    Try this link:...

    Try this link:
    http://www.classiczcars.com/forums/showthread.php?t=18761&page=2&highlight=door+rubber
  23. Replies
    9
    Views
    997

    I'm going to guess and say you got your...

    I'm going to guess and say you got your weatherstripping from too intense.

    Either way there is no quick easy fix. Once you do a search you will see that we've discussed this topic quite a bit....
  24. Replies
    32
    Views
    2,666

    What's up with all the oil spray on the front...

    What's up with all the oil spray on the front crossmember and steering rack?
  25. Thread: help

    by Ed
    Replies
    3
    Views
    953

    Rebuild kits (gaskets, rings & bearings) are also...

    Rebuild kits (gaskets, rings & bearings) are also available through your local auto parts store. Not the head though.
Results 26 to 50 of 96
Page 2 of 4 1 2 3 4