Search:

As mentioned before when i bought my car my EGR system looked like this:

74879

some of its components were not working and consequently i decide to remove the following parts from my engine:...

i logged into your website and dont see any available. Can you send me the link where it shows up and Price?

Does anyone in the fórum has an extra license plate light that will fit on my 1972 240z for sale? I do have the original one but it is bent by the heat taken throughout the last 42 years. JDM- Car...

Leon,

OKAY. Yesterday i removed the air filter, caburetor domes, inner springs and sprayed carb cleaner to both of the 3 screw SU carburetors. I refilled both carburetors with 3 in one motor oil...

Just checked and I dont see any signs of rust or impurities in the glass filter. I even checked all the spark plugs and they are burning well. I also sprayed carburetor clear to all the hoses end in...

Took the car again back to my mechanical engineer. Tested the car and it seems to accelerate fine. The problem is in the deceleration. When coming to a stop sign, slowing to make a u turn or traffic...

What about the original blue center caps? Where can i get them?

Are you sure those one fit? I read that the ones for Datsun 280zx wont fit these wheels. Can you verify?

I need 4 of center caps for these wheels with the clips intact:

Nissan Datsun 240Z 260z Original Wheels | eBay

Can someone point out which center caps fit these wheels? Will the 280zx fit? or...

Its a bit rough. The symptoms are the following:

Start the engine, drive on free way and everything is fine. Under this circumstances it idles between 1,100 and 1,200 rpm. However, if i get...

Okay, Im just about to change this Far 311 Race Cam which was installed by DATSUNLLC and was advised the following:

"a L26 crank makes your motor 79 mm stroke instead of the stock 73.7 mm
stock...

Just to let all of you know that i replaced the wáter temperature sensor, the old original thermostat housing and swapped the thermostat from 180° to 160°. I tested the car under heavy traffic on a...

I sprayed carb cleaner on each of the hoses and did not noticed any change on the idle speed. Can you address exactly where shall i spray directly the carb cleaner?

While looking for vacuum leaks which could be the main cause of the rough idling and stalling of my 240z i have decided to replace all of the fuel line and braided hoses in the engine compartment.
...

7437774378

Im having a similar problem. My car has a Far 311 Race Cam which is dropping from 1,100 to 500 RPM whenever i get stuck on heavy traffic, stalls and then dies. I did indeed remove the...

7435674357

My car has a recently installed Electric Fuel Pump! So this should not be the issue! I believe it must have a vacumm leak somewhere which is causing this rough idling.

Any clues?...

Just got stucked in a traffic jam for 20 minutes on saturday, bumper to bumper. RPM tended to lower from 1,100 to 800 and then 500 RPM. Had to pull the choke or step on the gas so the car engine wont...

Madkaw,

Im trying to get a solution without changing the Far 311 Race Cam back to the stock cam. Its gonna get really expensive if i need to revert to the original cam. Unfortunately in Panama...

Took my 240z for a spin yesterday and got into heavy traffic. RPM mantained at 1,100 in light traffic but once i started going bumper to bumper, the rpm started to lower to 800 rpm and the raised...

Can anyone send me the height and details between a 240z and 260z springs. Trying to purchase a set of rear OEM Factory used springs of a 260z and need to be sure they will give me the correct stock...

So should i just cancel my order and request a refund? its 80 dollars!

These are the springs i purchased from a 1974 260z with 32,000 miles :



74227

Just scored a used stock set of 2 front and 2 rear springs from a 1974 260z with 32,000 miles on ebay. will i be able to replace the springs on my car with these ones? Even though they are from a...

Just called Dave! He ran out of stock! What other alternative do i have to achive stock height and ride?

What about Arizona Springs? Since i only need to two rear ones? http://www.arizonazcar.com/springs.html

Should i purchase this set?

I still think the rear springs could be soft. The car does look low in the rear. What Brand of springs is recomendable? Eibachs? I want a smooth ride with the correct height of the car!