Search:

Type: Posts; User: wolfalp1592

Search: Search took 0.00 seconds.

  1. Replies
    12
    Views
    1,190

    Thanks for all the input guys. I went with JB...

    Thanks for all the input guys. I went with JB Weld. Had some on hand. I filled the hole and put a washer and nut on the back side of the hole for good measure. Now it holds like a champ.
  2. Replies
    12
    Views
    1,190

    Thanks guys on the oil issue. I was getting...

    Thanks guys on the oil issue. I was getting nervous about that. I can weld fairly well particularly when it doesnt show so that was my plan. It is just interesting to me the way some PO's take on...
  3. Replies
    12
    Views
    1,190

    Problem solved. This is interesting. Has any one...

    Problem solved. This is interesting. Has any one seen oil in this area before? Not sure what PO had going on. I think it was overfilled at some point. Good compression and but dirty engine.
    ...
  4. Replies
    12
    Views
    1,190

    Thanks guys.The picture helps alot.

    Thanks guys.The picture helps alot.
  5. Replies
    12
    Views
    1,190

    Thanks guys. I am trying to remove the...

    Thanks guys. I am trying to remove the distributor from the mount.
    Yes i have reviewed the FSM and found an exploded diagram but it does not indicate if there is a gear cog at the end of the shaft...
  6. Replies
    12
    Views
    1,190

    Distrbutor removal

    Another while I'm at it. Im replacing the distributor cap and rotor and notice one bolt/screw to hold down the cap ('82 turbo) has been replaced with a wood screw by po and it isnt working. I look at...
  7. That spot makes me nervous. I see holes that let...

    That spot makes me nervous. I see holes that let rain in and where is it going? There may be much more rust. You may not know until you get in there. It looks like the carpet is pulled back on the...
  8. Replies
    2
    Views
    1,322

    I have a factory radio from an '82 zx. It works...

    I have a factory radio from an '82 zx. It works moderatly well. I have not tried the tape player. The PO butchered the wiring harness in my car and I am not installing it so not sure if the back...
Results 1 to 8 of 8