Search:

a quick search online found a place called windshieldstogo with replacements at $125. Before going the online route, I'd call around to the shops from Waynesville to Asheville... as well as checking...

sure, you could go that route...if you have about 5,000 bucks to spare... or you could source an L28et motor from a turbo ZX...

Removing the trim from the upper and lower edges of the windshield is fairly easy; the vertical portions are less so.

To pop the upper SS trim, grab the trim near the center of the car, and pry...

The easiest thing to do would be to find a complete turbo engine, with all the control modules, and swap it in. Once it's in there, you could then start looking for turbo upgrades.
If you were to...

Did the exhaust system you bought from Advance come in on piece? That would be one heck of a shipping box... If it did, you should be able to snake it in with the car jacked, and the rear left wheel...

The antenna unit is pretty easy to remove and disassemble. Odds are you need to re-grease the drive mechanism. If I recall correctly, you only have to remove three screws on the antenna assembly,...

IMO, there is no reason to discount the 260. I think that due to it's limited production run, there's a level of uniqueness to an already unique line of car. If you search around, you'll find that...

Take a piece of felt and a good magnet when you look at the cars. Check the frame rails, underside of the floopans (even if the undercoating looks good, there can still be rust). Run the magnet over...

The noise suppressor is (or should be) mounted with the ignition coil, on the mounting bracket itself. It may well be disconnected, missing, or simply worn out...

Hopefully you won't find what I found under the rubber outer...
I was able to find a rear bumper from an 82 model (same extended rubber edges as on your year) but due to the extended section,...

Do you have a copy of the Factory Service Manual? If not, PM me your email and I'll forward you a PDF copy.
You'll be able to find all the routing for the vacuum lines, as well as electrical...

You could always get the full cap, and cut a hole for the sensor...after measuring and marking it's location a few times of course.

Roman, the pics you posted are for the s30 cars, not the later s130 (280zx) cars, though I'm sure you know this already.
No, you don't have to remove the dash, just clean yours really well before...

http://nashville.craigslist.org/cto/2734814526.html
Yes, it's in the Nashville, TN area, but for the money, you might do well to consider it...

(though I wouldn't doubt if the car has 167,000...

There *should* be a thin plastic piece with little hooks/barbs on it running the length of the glass, in the gap between the glass and the body. Yours may be there, but those little parts that clip...

After some searching, I finally found a few of the Nissan Skyline 2000gt-r

Gotta give kudos to the folks at Mattel for choosing such a cool car, and for the detailing.

Actually, the S130 fuel tanks do not have a drain plug but loosening/removing the fuel filler hose (at the tank, obviously) will do the trick, though this method doesn't completely remove all the...

Welcome to the forum.

I have a couple thoughts on your particular issue... it sounds to me as though you are having a fuel starvation issue; that it occurs once the engine is warmed up may be a...