Search:

Type: Posts; User: txvepr

Page 2 of 2 1 2

Search: Search took 0.00 seconds; generated 53587 minute(s) ago.

  1. Replies
    11
    Views
    1,737

    Maybe the last post for this one. Can an...

    Maybe the last post for this one.

    Can an electric motor be 'bad' and still spin if you apply 12volts to it off the battery alone?

    1. I can get it to spin if I wire it direct to the battery.
    2....
  2. Replies
    11
    Views
    1,737

    To keep this mildly interesting. I removed the...

    To keep this mildly interesting. I removed the front ac control covers to start checking the micro switch and fan blower switch.
    I could show a circuit continuity from the micro switch, and each of...
  3. Replies
    11
    Views
    1,737

    Ok, more work done with no luck yet. I pulled...

    Ok, more work done with no luck yet.
    I pulled the blower motor and did a simple ops check. It spins with 12 volts on it.

    I then pulled the AC relay switch, and opened it up. I saw some charring....
  4. Replies
    11
    Views
    1,737

    Well crud. Readin' and stuff shows me wrong...

    Well crud.
    Readin' and stuff shows me wrong area of focus... my bad.
    AC relay out in the black box in engine bay.

    Anyone found alternative supplies for that AC relay? AZ and Oreillys dont show...
  5. Replies
    11
    Views
    1,737

    This is a 3 speed fan switch. Can you tell me...

    This is a 3 speed fan switch. Can you tell me which one in the picture that is if possible?
  6. Replies
    11
    Views
    1,737

    Fan Blower just stopped working

    Have been running the AC on my 78280Z blowing cold for a couple of months now. Yesterday it worked all day. Today I turn it on and nothing. Even with just fan only I get no air blowing.

    I have...
  7. Replies
    3
    Views
    446

    I will check out the mounting and rubber...

    I will check out the mounting and rubber insulation next.
    Here is a pic of the ?original line? You can see where the large end looks like it was molded that way, not just simply stretched around the...
  8. Replies
    3
    Views
    446

    Fuel Line Question

    I have been replacing 38 yr old fuel lines and now have an annoying problem.
    I can now hear my fuel pump whine fairly loudly when the engine is started. Like you can hear it over the idle of the...
  9. Replies
    4
    Views
    574

    I did the switch! Got a Ignition Module from...

    I did the switch! Got a Ignition Module from Autozone part#DR100 and wired it up per the instructions found on this site.
    I was a little unsure of it until I cranked her up and it runs Great....
  10. Replies
    4
    Views
    574

    Yup. about the rotor wiggle, have you ever...

    Yup.
    about the rotor wiggle, have you ever noticed how much a good one has? I just never took note before.
  11. Replies
    4
    Views
    574

    A Distributor Question

    I have read all the posts I can find on this site, and the manual for this answer. Some are close, but maybe not exactly my problem.
    My newly acquired 78 280Z has a problem where at around 3000...
Results 26 to 36 of 36
Page 2 of 2 1 2