Search:

What are you using to try and straighten the bracket? I would make something specific for the job. Use those fab skills. Then put the car on a lift so you can really get under there. Put a 5' cheater...

You should try masking carefully but I think it would be a lot of work. Personally I would paint the whole thing then after it was dry take some 220 grit wet sand paper and carefully start removing...

The # 2 location the cam gear is to compensate for a timing chain that is old and stretched out. Refer to your FSM. There are diagrams that show where your timing marks should be. To me it doesn't...

Since you recently completed a rebuild you should double check that the assembly went as required. Start with the timing. Put your engine at TDC and make sure the distributor shaft is in the right...

Any hardware store it's called "rope caulk" not as sticky as the factory black stuff but it works just as good and cleans up much easier.

Bahh, bad ass is all i've got to say. Looks Good!

Just goes to show you that once you've been bitten by the "Z" nothing else matters!

Go with a 2 1/2 or smaller. Tell him you want aluminized steel. welded at all the seams. Resonator in the middle before the split then some dynomax or whatever your choice of muffler at the end. If...

Ha, i did it again. Now I'm living in Louisiana. Gotta love them shrimp!

turtle wax has a product in a green bottle formula 2000 or F21 that supposedly has no silicone

dynomat or brown bread all the same

Hey, I forgot about this post. Hope it works out for you. Remember to create a mirror image of the templete for the opposite side.

Does anyone know the dates? Or a link?

I've heard this is not a good idea. If the car isn't run at full operating temperature at highway speeds for atleast 30 minutes, condensation in the fuel system, exhaust system, cooling system and...

What type of straight edge did you use on the head? You need one that will go from one end to the other AND be precise. Take it to a shop and have them use a precision straight edge and pressure test...

You can get the correct size freeze plugs at any auto parts store.

first find a donor tray. Then once you know what you have start cutting.

Stay away from the 4 bbl. Less HP than stock S/U's.

Try your local auto parts store. If they can't get it then go to your local Nissan dealer. Then go to mail order MSA, Black Dragon or ebay.

I don't think your problems are related to any recent work that you have done. First off let me ask what type carbs do you have (flat tops or round tops)? Second what type of ignition are you...

Mine are the sloted mags, I had them machined finished with the slots painted to match the rear tail light trim.

BTW how do you load a picture from your computer onto the post so it doesn't show...

Haven't noticed this advertised anywhere.

Ontario, Canada Z club car show August 26th, 2007.

http://www.ontariozcar.com/eventz/EventCalendar/Z-FEST2007%20Flyer.pdf

One of the biggest shows...

ARghhh, that blows. Well atleast you will get them sooner or later. Have you checked with MSA? Do they have a backorder?
I think you should let me run them for a bit to make sure they will work...

The officer told me that since 1992 the law changed to where the drivers and passengers windows werent able to be darker than 75%. I've had the car in NY since 2002. I tinted the windows in 2003.

I don't know what the fine is. Ticket doesn't say. My options are to plea guilty and mail in the ticket. I assume I'll get the fine afterwards. Or to plea not guilty and go to court.
BTW it was...